ISO7641FMDWR UART Interface IC Digital Isolators 6kVpk Low Pwr Quad Ch,150Mbps Dig Iso

1 Features

• Signaling Rate: 150 Mbps

• Low Power Consumption, Typical ICC per Channel

  (3.3-V Supplies):

  • – ISO7640FM: 2 mA at 25 Mbps

  • – ISO7641FM: 2.4 mA at 25 Mbps

• Low Propagation Delay: 7-ns Typical

• Output Defaults to Low-State in Fail-Safe Mode

• Wide Temperature Range: –40°C to 125°C

• 50-KV/μs Transient Immunity, Typical

• Long Life With SiO2 Isolation Barrier

• Operates From 2.7-V, 3.3-V, and 5-V Supply and Logic Levels

• Wide Body SOIC-16 Package

• Safety and Regulatory Approvals

  • – 6000 VPK / 4243 VRMS for 1 Minute per UL 1577

  • – VDE 6000 VPK Transient Overvoltage, 1414 VPK Working Voltage per DIN V VDE V 0884- 10 (VDE V 0884-10):2006-12

  • – CSA Component Acceptance Notice 5A, IEC 60950-1, IEC 61010-1, and IEC 60601-1 End Equipment Standards

  • – TUV 5 KVRMS Reinforced Insulation per EN/UL/CSA 60950-1 and EN/UL/CSA 61010-1

  • – CQC Reinforced Insulation per GB4943.1- 2011

    
    

2 Applications

• Optocoupler Replacement in: – Industrial Fieldbus
• – Profibus INx – Modbus
• – DeviceNetTM Data Buses

• – Servo Control Interface

• – Motor Control

• – Power Supplies

• – Battery Packs

ISO7640FM and ISO7641FM provide galvanic isolation up to 6 KVPK for 1 minute per UL and VDE. These devices are also certified up to 5-KVRMS Reinforced isolation at a working voltage of 400 VRMS per end equipment standards EN/UL/CSA 60950-1 and 61010-1. ISO7640F and ISO7641F are quad- channel isolators; ISO7640F has four forward and ISO7641F has three forward and one reverse- direction channels. Suffix F indicates that output defaults to Low-state in fail-safe conditions (see Table 4). M-Grade devices are high-speed isolators capable of 150-Mbps data rate with fast propagation delays.

Each isolation channel has a logic input and output buffer separated by a silicon dioxide (SiO2) insulation barrier. Used in conjunction with isolated power supplies, these devices prevent noise currents on a data bus or other circuits from entering the local ground and interfering with or damaging sensitive circuitry. The devices have TTL input thresholds and can operate from 2.7-V, 3.3-V, and 5-V supplies. All inputs are 5-V tolerant when supplied from 3.3-V or 2.7-V supplies.

Device Information